Skip to product information
ZionYEE Ultra-Matte Flower Joy Pink Car Wrap 5×50ft
$69.99
Sale price
$69.99
Regular price
$104.99
Give your car a completely new identity with the ZionYEE Ultra-Matte Flower Joy Pink Car Wrap — a 5×50 ft roll of premium cast vinyl engineered for a smooth, paint-like finish. Air-release channels make positioning forgiving, and a self-healing top coat keeps the surface looking fresh long after install. Professional results, DIY-friendly.
Ultra-matte finish, built to be noticed
- Ultra-matte look. A soft ultra-matte pink with zero glare — bold colour, flat finish.
- Air-release adhesive. Micro air channels let you lift and reposition the film, so bubbles push out instead of getting trapped.
- Self-healing top coat. Light swirls and scuffs level out again with a little heat from the sun or a heat gun.
- Conformable cast vinyl. Soft enough to hug bumpers, mirrors, door cups and deep recesses without fighting you.
- Clean, residue-free removal. Comes off with heat and leaves OEM paint underneath intact — ideal for leased cars.
- Built for the outdoors. UV-stable pigments and a weather-resistant face film stand up to sun, rain and road salt.
How to install
- Degrease & clean. Wash and degrease the panel, then wipe it dry. Any wax or silicone will fight the adhesive.
- Measure & cut. Measure the panel and cut a sheet with 5–10 cm of extra material on every edge.
- Wet & position. Spray the panel with install solution, peel the liner and float the full sheet into place.
- Squeegee out solution. Work from the centre outwards with firm, overlapping strokes to drive the solution out.
- Heat & wrap edge. Warm the film and wrap it around the edge, pressing it tight so it grips the return.
- Trim & seal. Trim flush along the edge and post-heat the whole panel to lock the film in place.
Specifications
| Product | ZionYEE Ultra-Matte Flower Joy Pink Car Wrap Vinyl |
|---|---|
| Finish | Ultra-matte |
| Roll size | 5 ft × 50 ft (approx. 1.52 m × 15.2 m) |
| Film type | Cast vinyl, conformable |
| Adhesive | Air-release, repositionable |
| Liner | Self-healing PET liner |
| Application | Wet or dry (wet recommended for large panels) |
| Typical use | Full or partial vehicle wraps, interior trim, accents |
| Removal | Heat-assisted removal, residue-free on sound OEM paint |
Care & removal
- Wait 24–48 hours before the first wash so the adhesive can fully cure.
- Hand wash with pH-neutral car shampoo. Avoid abrasive brushes and automatic brush washes.
- Skip solvent-based cleaners and waxes with polishing compounds on matte and textured films.
- To remove, warm the film to around 60 °C and pull it back slowly at a low, flat angle.